The Mod Collective: Bring all your IEM mods here.

[dhruvmeena96]

I think the data sheet is wrong. No way it’s 100os. I am pretty sure they missed a decimal place (In other words, 10.0 ohms).

i have used that driver

its 100ohm on DCR
111 ohm on 500Hz
124ohm at 1kHz

worry not if your DD is in fullrange, a low impedance reaction will fix its high rising impedance

but if you are on 2 way cross, then its an issue

 

[Slater]

I wonder if it was a custom spec driver? Because the bare driver measured 13.2ohms DCR.

Either way, it’s buried in resin now, so I can’t change it lol

 

[dhruvmeena96]

I wonder if it was a custom spec driver? Because the bare driver measured 13.2ohms DCR.

Either way, it’s buried in resin now, so I can’t change it lol

Do post on home made iem also

Well how does it sound ?
Compare to ChiFi

 

[Wgibson]

Not sure if this is the right place, but search took me here.

KZ ATE mmcx mod, did the cable too with male connectors just for soldering practice. Not too pretty, but it works. Also has red mesh replaced with stainless, normally I'm a bit treble sensitive but haven't met a single DD yet that was too much. KZ ATR pictured also.

IEM, connectors, heat shrink, and B7000 glue.

 

[Slater]

Not sure if this is the right place, but search took me here.

KZ ATE mmcx mod, did the cable too with male connectors just for soldering practice. Not too pretty, but it works. Also has red mesh replaced with stainless, normally I'm a bit treble sensitive but haven't met a single DD yet that was too much. KZ ATR pictured also.

IEM, connectors, heat shrink, and B7000 glue.

Nice job

 

[Dave Drums]

What are people using for aftermarket Y Splitter cables?
I could really use some advice, mainly because I'm not exactly sure what the industry name is for this product?

You know, when the parting for left and right ears is either too high up or too long, and you want the cables to break out at a different length, what are people using to add their own pinchable Y splitter? Are there one's that don't require removing any plugs and resouldering to get them on the cable?