coacharnold
New Head-Fier
- Joined
- Feb 4, 2011
- Posts
- 24
- Likes
- 10
OK ..... trying to do a mod on the 4G ipod .... all i get from the guide you guys sent .....(that works ) is this
does everyone agree .... don't remove the caps and inductors?
how about wiring .... is it all the same .... if I want to keep the headphone out up ...... and make the line out work .... what caps should I use .... are they needed? do i have to build a dock connector ..... can I fit caps in me case ....
there's a lot of information on the forum and it's not very step by step clear..
T
C.A iPod 4G photo - done by vvs_75, KerryKing, no_eye_dear, funch
does everyone agree .... don't remove the caps and inductors?
how about wiring .... is it all the same .... if I want to keep the headphone out up ...... and make the line out work .... what caps should I use .... are they needed? do i have to build a dock connector ..... can I fit caps in me case ....
there's a lot of information on the forum and it's not very step by step clear..
T
C.A iPod 4G photo - done by vvs_75, KerryKing, no_eye_dear, funch
Notice - Do not remove caps and inductors. Simply solder wires to and from the correct pads. Removing C's and L's will increase the risk of lifting the pads and disabling any type of audio output from your logic board.
Figure C.A
Take the signals from the north pad. Please note that the board is upside down here, and north refers to the end of the board at which the headphone jack lies. Thanks for hounding me, funch.
Image courtesy of ipodlinux.org.