Correct.
All these (VCCL/VCCR/VCCC/VCCF) are linked together and +5V. C410 which you already fitted Os-Con is also connected there. Better to replace C410 with Elna Silmic.
That is very difficult to solder by hand. You might find that the small cap comes off the PCB even with just soldering on one side. Leave C412/3/4 alone.
Plus, the VCOM Cap (C411) you should really remove the small ceramic cap and put something better in place. I would stll recommend 1uF 63V Wima:
https://www.mouser.com/ProductDetail/WIMA/MKP2C041001N00MN00?qs=RB4whv9F6rzjnMhXY4f0hA==
Only C411.
The others lave as is.
if you can find C404 (likely under the PCB and you have enough space, adding an extra os-con there would help, that is the clock supply.
I cannot remember, I used what was readily available at the time of design.
Maybe 2.2F/2.7V * 2 in series. They had a pretty fat inductor with some DCR in the +5V line to limit current.
Thor