Slater
Headphoneus Supremus
Is there any re-cable guide or how-to ?
No real guide needed.
You stick a wooden toothpick into the vent hole on the top of the shell, and pop the shells apart. Then you desolder the stock wire from the driver. Then you resolder the new wire to the driver, and snap the shells back together. No glue needed. There is a black mark on the stock driver to indicate the ground terminal.
The hardest part is making sure you don’t overheat the driver and destroy it. You should only touch the solder pad with the soldering iron for a fraction of a second at most. Anything over 1.0 second will cause damage.
Also, if you buy thin enough wire it will work with the stock wire strain reliefs. It’s only when you go with thicker or braided wire that you have to get creative with the wire strain relief. I don’t recommend going thicker though, as if you don’t know what you’re doing you will drastically change the sound tuning. You want a wire that fits tight with the stock wire strain relief, so it doesn’t turn the strain relief into an additional bass vent.
Last edited: