i ordered the crack too and i plan to get either the 600s or the 650s by the time i get it built. which one pairs better with the crack? it was probably discussed before, but opinions change, new people join the thread, that's why i'm asking. thanks!
They should both pair equally well given their power requirements are mostly the same. So it's more of a question about the headphones than the amp. Much has been written about the differences and similarities between these two headphones. If you want a personal recommendation, you'd probably need to provide a bit more about the types of music you like and if you have any preferences regarding sound signature.
i ordered the crack too and i plan to get either the 600s or the 650s by the time i get it built. which one pairs better with the crack? it was probably discussed before, but opinions change, new people join the thread, that's why i'm asking. thanks!
I would say that you cannot go wrong with either one, unless the tonality (bump) differences are deal breakers for you. I like the sound of both HD600 and HD650 with my Crack/Speedball.
Well yes and no. There are some that listen to their headphones from the line out of a dac and swear by it. I haven't tried it myself but ... I guess there is some sort of a amp circuit to get a line level output don't know that much about it to say for sure. I am one that wants all the power I can get for all my cans and speakers for that matter. It is not to just make it loud .
I'm no electronics expert but when a headphone has an impedance of 300ohm likeI'm PRETTY sure you need the proper amount of power to get the driver moving. Not just moving a lot (volume) but with good control (less distortion).
I had it described to me this way:
A low impedance headphone (i.e. 32 ohm) has a more loose driver & is easily moved with less power but
can be a more "flabby".
A high impedance driver (i.e. 300+ ohm) is more stiff & requires more oomph to get it going. Since the driver is more stiff it returns to "0" quicker, giving better accuracy.
I'm no electronics expert but when a headphone has an impedance of 300ohm likeI'm PRETTY sure you need the proper amount of power to get the driver moving. Not just moving a lot (volume) but with good control (less distortion).
I had it described to me this way:
A low impedance headphone (i.e. 32 ohm) has a more loose driver & is easily moved with less power but
can be a more "flabby".
A high impedance driver (i.e. 300+ ohm) is more stiff & requires more oomph to get it going. Since the driver is more stiff it returns to "0" quicker, giving better accuracy.
The impedance is caused by winding wire around the voice coil. It's not the stiffness of the drive unit. The higher the impedance the more winds on the voice coil.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.