My first DIY questions -CMoy- (picts)

[ph33lix]

You might want to start reading up at least on the different components, schematic symbols, units (micro farads, ohms, volts... etc) and such.
Do you at least have the same board that tangent recommends or the one that Bullseye is using?

 

[zkool448]

Quote:

Originally Posted by xkRoWx /img/forum/go_quote.gif Bahhh, zkool448 you might want to guide me through with my cmoy too. I'm so bummed right now, I don't know how to bridge my board to the one shown in Tangent. Not being able to read schematics doesn't help, either.

xkRoWx, I noticed that you are also in Toronto. Unlike bullseye, you have access to the protoboard Tangent recommends. The Source carry the board and no need for you to make your own solder traces, just a couple of jump wires from +/- to the opamp pins.

Check their stock for availability before heading over the store.

zk

 

[Bullseye]

Great!

Power supply working correctly, amp section can not test it as I do not have alligator clamps.

Gonna start working the tin in order too make all the things fit. I have a massive dual 10K potentiometer, that will fit in the tin, but will make things harder

 

[ph33lix]

You can solder the connectors and such and still test... most importantly, with a cheap set of earphones that you won't miss should they die.
Good idea to test it now than later when you're at the point of "goddammit, i have to take all of it out to test?". LOL