Hello guys
I have been a lurker for many years and I have a Little Dot MKIII that I use as a pre-amp which is also a superb use for the LD
I run the Military spec Mullard 4015 EF92 driver tubes and a pair of Sovtek 6H30P-EV power tubes
I have been using two solid state D amps in vertical bi-amping mode on a set of XTZ 99.25`s Now I upgraded to a Naim NAP250 Clone amp and started tube rolling again
I have been happy with this setup for many years now. But the new amp has a different soundscape that needs some tweaking.
I noticed the C3G upgrade with adapters and the 6SN7 power tubes with adapters. I have removed my brass rings today and I have ordered adapters for both power and drivers.
So I have some questions for you guys.
1. It is basically the same what C3G`s I get since only Lorentz & Siemens made the C3G`s? And the jumpers need to be in EF95 mode? An eBay seller from Germany has some brand new Siemens that I am considering.
2. For power tubes, some Tung-Sol reissue 6SN7GTB should be good or a couple of Sylvania 6SN7GTB?
Thanks :3