Made some progress today on the beast.
Heat sink is all prepped and ready for regulators, holes are drilled for three Maidas and four Rod Colemans.
Mounted the Hammond filament transformers and raw DC supplies, should be able to get the filament supply up and running tomorrow, then testing of the B+ supplies will begin.
I should build all amps on plywood! Low stress, no worries about precise measurements, comes together quickly too
Heat sink is all prepped and ready for regulators, holes are drilled for three Maidas and four Rod Colemans.
Mounted the Hammond filament transformers and raw DC supplies, should be able to get the filament supply up and running tomorrow, then testing of the B+ supplies will begin.
I should build all amps on plywood! Low stress, no worries about precise measurements, comes together quickly too
Last edited: