-
-
Tjj226 Angel replied to the thread Where should a clumsy useless fool like myself get started with DIY? 😂.You are going to have to learn about electronics to some degree in order to properly design a set of speakers. Most speakers require a...
-
Tjj226 Angel replied to the thread Low-power speaker amps as headphone amps.You really want to be using a resistor divider instead of a simple inline resistor. This page here goes into detail about what values...
-
Tjj226 Angel replied to the thread Is there a list somewhere of existing DIY headphone amp plans?.It's not impossible to build a 300b amp for under 1K. You will have to put in more work, but it is doable. Antek and edcor are your...
-
Tjj226 Angel replied to the thread Is there a list somewhere of existing DIY headphone amp plans?.It's gonna be tricky to keep it under 1K, but there are designs out there that will work. Here is a solid design that can get you...
-
Tjj226 Angel replied to the thread Gadget to measure headphone output impedance?.You could just use a dummy resistor and a multimeter and get a close approximation for cheap. But why are you doing this and what do...
-
Tjj226 Angel replied to the thread Aegis DIY Tube Headphone Amplifier.Mkay
-
Tjj226 Angel replied to the thread Aegis DIY Tube Headphone Amplifier.Lol. K.
-
Tjj226 Angel replied to the thread Aegis DIY Tube Headphone Amplifier.Have you confirmed you even need to switch the winding outputs? I would have to sit down and do the math to figure out what sort of gain...
-
Tjj226 Angel replied to the thread L0rdGwyn's DIY Audio.Be very careful with monolith. They do make some decent stuff, but you have to be very judicious and read the spec sheet carefully. For...
-
Tjj226 Angel replied to the thread Replacement Output Caps for Singlepower SDS tube amp (OTL)?.Maybe I am confused or something, but what part of what I said makes you think I wouldn't agree that film caps are better than...
-
Tjj226 Angel replied to the thread Replacement Output Caps for Singlepower SDS tube amp (OTL)?.I have tried several mundorf caps in several projects and none of them sound good. You should take a look at temco motor run caps...
-
Tjj226 Angel replied to the thread My DIY electrostatic headphones.Just to clarify, did he switch back to probias because he liked the sound better or because it was easier to live with the pro bias?
-
Tjj226 Angel replied to the thread DHT tubes compatible with 5 Volt, 4 Volt and 2.5 Volt heater voltage?.The 71 and 71a would be the only other tube I know of that can be used as an output tube with a 4 pin base that meet those heater...
-
Tjj226 Angel replied to the thread My DIY electrostatic headphones.Out of curiosity, has anyone tried to go for a relatively loose tension on the mylar? Im thinking about using water tension to stretch...
-
Tjj226 Angel replied to the thread My DIY electrostatic headphones.Since you are in the UK, you should probably reach out to sowter and get some quotes on custom transformers.
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…