Monolithic
Head-Fier
- Joined
- Jan 24, 2009
- Posts
- 68
- Likes
- 10
@b0bb - A few questions regarding upgrading to 1.3v on the Gen2 board:
1) Any reason to leave the C1/R1, C2/R2 pairs on the board after removing the regulators? I'm assuming C1/C2 are charge pump caps and R1/R2 are feedback/set resistors
2) For the input wire, did you run a flexible wire from the C3/C4 smd caps (yellow dots) to the Belleson regulators? I didn't know if two points of through hole support were enough to handle the heatsinks. Was thinking of possibly using a third stiff wire to the input cap through hole as well, but it appears to be a fair distance away (red dots indicate through hole mounting points). (C5/C6 along with output E-caps are moved onboard with respective Belleson regulators)
Thanks.
1) Any reason to leave the C1/R1, C2/R2 pairs on the board after removing the regulators? I'm assuming C1/C2 are charge pump caps and R1/R2 are feedback/set resistors
2) For the input wire, did you run a flexible wire from the C3/C4 smd caps (yellow dots) to the Belleson regulators? I didn't know if two points of through hole support were enough to handle the heatsinks. Was thinking of possibly using a third stiff wire to the input cap through hole as well, but it appears to be a fair distance away (red dots indicate through hole mounting points). (C5/C6 along with output E-caps are moved onboard with respective Belleson regulators)
Thanks.