spyder25000
New Head-Fier
- Joined
- Mar 7, 2014
- Posts
- 14
- Likes
- 0
I've been using my ZSR's but not a fan of the comply's
What silicon eartips do you recommend for the ZSR?
What silicon eartips do you recommend for the ZSR?
So are they flat line-ish sounding? Are they warm or clinical? Anyway to compare sound to Havi B3pro1 as you mentioned wide stage. Havi is monsterous and has good up and down for a full 3d effect. For me Havi is/was the gold standard of under $50 iems. Would you rather have Havi or AS10 if you could only choose one?My early impressions of KZ's new five balanced armature earphone, the AS10; https://thecontraptionist.blog/2018/08/04/kz-as10-first-look/
My early impressions of KZ's new five balanced armature earphone, the AS10; https://thecontraptionist.blog/2018/08/04/kz-as10-first-look/
Thanks for your impressions. They look quite promising! Could you please give aaquicj opinion egarding isolation? Are they vented?
The next request wouldn't be so quick but would be quite welcome: how do they compare with the IT01 and the B400?
Thanks!
So are they flat line-ish sounding? Are they warm or clinical? Anyway to compare sound to Havi B3pro1 as you mentioned wide stage. Havi is monsterous and has good up and down for a full 3d effect. For me Havi is/was the gold standard of under $50 iems. Would you rather have Havi or AS10 if you could only choose one?
I've been using my ZSR's but not a fan of the comply's
What silicon eartips do you recommend for the ZSR?
My early impressions of KZ's new five balanced armature earphone, the AS10; https://thecontraptionist.blog/2018/08/04/kz-as10-first-look/
its better on cymbal than zs3. i tried the song 8 times
plus everyone
actually i fixed my KZ ES4 by a huge margin. and some of my iem
i noticed that on the left earpiece, pressure relieving port was smaller than right(KZ ES4)...
i just used a needle and tried to widen the hole without puncturing the vent
spinfit cp240 was used
and viola
fixed
its not the problem with our ears, but the ability to find problem before blaming ourselves
at this price, you think it's going to be knowles?!Are you able to see the drivers through the gaps in faceplate.
Two of the drivers seem to be knowles and used is several other higher price products like Magaosi K5 etc. I wonder why they decided to go with opaque body and hide their drivers, rather than show it off like ZS10.
How do you reckon KZ managed that?22955 & 30095 are Knowles.
22955 - http://www.mouser.com/ds/2/218/-532680.pdf
30095 - https://www.mouser.com/ProductDetail/Knowles-Johanson-Manufacturing/WBFK-30095-000?qs=Q97emo0LRppk1/KuN5A0rw==
You probably need an a**-tight production area to create the push-pull drivers. Any less tight would yield serious QC problems. I mean look at the photo: the left earpiece has the KZ emblem upside-down!
How do you reckon KZ managed that?
Try this simple test, put on a set of iems and listen - establish that you hear the imbalance, then switch the earpieces between left and right. If the imbalance switches sides, it is in the device chain, if the imbalance is still where it was to start with, it is your hearing and time to go see an audiologist.