Patrick82
Banned
- Joined
- Mar 1, 2003
- Posts
- 3,745
- Likes
- 17
Previously I had 22awg Valkyrja soldered to the binding posts, it was 35cm long, and it was soldered to a 16awg Valhalla power cord, but it didn't work good because the solder joint came loose a couple times a month. Today the solder joint inside K1000 came loose because the pulling from Valhalla is so strong. I have opened up my K1000 now and they are nude on my table, what will I do to them? The 16awg conductors don't fit through the hole of the rubber thing.
Also, soon I will receive a Virtual Dynamics Genesis cable for my headphones to replace my Valhalla, it weighs like 20 lbs. I'm worried that it will not work so good. Should I build some kind of helmet to plug the Genesis into?
Or maybe I should just install a short stock cable and plug it into the Genesis which is resting beside my keyboard?
Also, soon I will receive a Virtual Dynamics Genesis cable for my headphones to replace my Valhalla, it weighs like 20 lbs. I'm worried that it will not work so good. Should I build some kind of helmet to plug the Genesis into?
Or maybe I should just install a short stock cable and plug it into the Genesis which is resting beside my keyboard?