fredpb
1000+ Head-Fier
- Joined
- Dec 8, 2001
- Posts
- 1,405
- Likes
- 1
How would you remove the earpads for both the HD600 and the HD570? Mine are about due for replacement.
How to remove Sennheiser earpads?
- Thread starter fredpb
- Start date
Beagle
His body's not a canvas, and he wasn't raised by apes.
- Joined
- Jun 29, 2001
- Posts
- 9,257
- Likes
- 3,633
Grab ahold of the areas covered with fur and pull hard, careful not to tear them.
And for goodness sake, when putting them back on, remove the rear grills first as there is a tendency to press on them when applying force to get the pads back on, and this can dent the screen.
And for goodness sake, when putting them back on, remove the rear grills first as there is a tendency to press on them when applying force to get the pads back on, and this can dent the screen.
JohnR
New Head-Fier
- Joined
- Jun 20, 2002
- Posts
- 32
- Likes
- 0
Quote:
I use a small screwdriver to lever off the 570s pads as they are quite firm compared to the 600s. Pulling with just your hands may tear them a bit.
| Originally posted by fredpb How would you remove the earpads for both the HD600 and the HD570? Mine are about due for replacement. |
I use a small screwdriver to lever off the 570s pads as they are quite firm compared to the 600s. Pulling with just your hands may tear them a bit.
j-curve
100+ Head-Fier
- Joined
- Apr 15, 2002
- Posts
- 489
- Likes
- 11
Quote:
I'll take the bait - How do you remove the grills without leaving any dints or scratches? Are any screwdrivers or coins necessary?
Also a tip for the earpads. Pull them from the outer edge at the front or back (the places of least curvature) until the plastic backing becomes visible. Then you can safely lever that plastic ring. Pulling from the inside edge is not such a great idea since that's where they clip to the frame.
| Beagle: remove the rear grills first... |
I'll take the bait - How do you remove the grills without leaving any dints or scratches? Are any screwdrivers or coins necessary?
Also a tip for the earpads. Pull them from the outer edge at the front or back (the places of least curvature) until the plastic backing becomes visible. Then you can safely lever that plastic ring. Pulling from the inside edge is not such a great idea since that's where they clip to the frame.
Users who are viewing this thread
