mrravioli
Head-Fier
- Joined
- Sep 29, 2016
- Posts
- 51
- Likes
- 10
Plate is attached with two small screws, then the back slides out.
https://emotiva.com/wp-content/uploads/2017/05/stealth_DC-1_user_v15.pdf
Page 13
Stealth DC-1 Stereo D/A Converter - Operators Manual
Hardware Configuration
Inserting or changing batteries in the remote control
The Stealth DC-1 remote control is opened by removing the two small screws in the
bottom end cap (the end without the LED).
Once the screws are removed, the end cap will come off, freeing the back plate to slide
out. Carefully slide the back plate all of the way out and remove it.
Insert two AAA batteries into the battery holder - observing proper polarit
y.
(We recommend alkaline batteries.)
Replace the cover, being careful to engage the edges in the slots in the side pieces, and
keep the end with the rubber pads towards the battery holder.
Replace the end cap and the screws.
Note: The remote control ships with batteries installed, but with a small
insulator strip between the batteries and battery terminal to prevent
discharge during shipping. Before using the remote control for the first time,
you must open the remote control and remove (pull out) the small insulator
strip between the end of one of the batteries and the battery terminal.
Note: The screws securing the end cap of the Stealth DC-1 remote control are
tiny. A screw driver of the correct size is included with your DC-1
Thanks. Actually I read the manual and opened up the end cap. My problem is the inner back plate does not ‘slide out’ as indicated in the manual. I attached a pic above. Could you shed some light on what should I do? Thx a lot!