vantt1
Headphoneus Supremus
@vantt1 the operating voltage is DC 3V, that is the output on wrote on the plug - how do i upload picture by the way? so I can show you what I thought and verify with you - I think the setup should be very similar to your beats bluetooth. I want to upload the diagram I draw for wiring and share.
You can't upload pictures until you have more than 10 posts I think.
and is there any tear down beats by dre studio 2 Video btw? that will help a lot
Probably not. The new design's earcups are covered with a silicone cover on the back, which are impossible to reinstall after you take them off. The headband is also really tricky to put back together. I took it apart one, never again. The headband cushion is now loose along the edge.
PLAN:
http://www.ebay.com/itm/li-polymer-rechargeable-baterry-Lithium-ion-300-mAh-3-7v-602030-for-mp3Bluetooth-/281272835089?pt=US_Cell_Phone_PDA_Batteries&hash=item417d2adc11
I am planning to get this as this is exact voltage and ma on the plug and the "beats bluetooth" tear down picture with the micro usb charging module - http://www.ebay.com/itm/1pcs-5V-MICRO-USB-1A-Lithium-Battery-Charging-Protection-in-one-Board-Module-/300919267742?pt=LH_DefaultDomain_0&hash=item46102fa19e
After I make sure it work with this modules combo, i will try to get the bluetooth to work if it is not too complicated, otherwise I will just do the normal adding removable cable mod for headphones showing on youtube. http://www.youtube.com/watch?v=0JHGJqfM0wE
SETUP:
My thought of the wiring diagram is like the fallowing -
(Battery -> charging port ) or ( the DC plug for the demo version) -> to the battery indicator -> amp with the noise canellation -> headphones drivers
Demo Unit for
http://www.ebay.com/itm/Beats-by-Dr-Dre-Beats-Studio-2-0-Over-Ear-Headphones-Red-Display-Model-GREAT-/201189118360?pt=US_Headphones&hash=item2ed7ce5198
1.) it should be very easy to test out if the above battery modules work or not, it is a y-cable connect to the earphone cup - one side is the power and the other side is the 3.5mm jack before it is split, so instead of like the previous try in the earlier in the thread, I will cut it before it COMBINED to one cable, so i dont worry about to confuse which one is which. once this is work then I will tell you guys the next step.
and the source input should connect directly to the amp with the 3.5mm jack, so if would like to add bluetooth it should be just switch the 3.5mm jack to the bluetooth module - but I am confusing how power this up, which I need vantt1 for help on this
I am also want to get this pair of bluetooth headphones similar to the beats studio setting - http://www.ebay.com/itm/141409130638?_trksid=p2060778.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT - if the modules metioned above is not working
Any idea or suggestion will help!
I think the New Beats Studio has a lot less tolerance for circuit boards that weren't originally designed for it, so a new circuit may be a problem. The old Beats Studio was a cinch, because the cavity was a uniform cylinder.