j4cbo
100+ Head-Fier
- Joined
- May 13, 2006
- Posts
- 118
- Likes
- 0
I'm reposting this from inside another thread on HeadWize, since this forum gets more traffic.
I was playing around with case designs over the vacation, and came up with this...
- Based on the new Kevin Gilmore Dyna-GBF-FET design
- The base is 10" by 12"; room for two Power One HCC24-2.4-A supplies, +/-24V at 2.4A each
- Boards are 2.5" diameter; columns are 6" tall
- Outer supports are 3/16" threaded rod with 1/4" brass tubing over it
- Inner column is 1/2" diameter, but it could be increased to 3/4"
- Inter-stage connections are lined up board-to-board, vertically
- Power and output connections go through the center column
- Heatsinks are not pictured, but Aavid has plenty in the right range (< 16 C/W)
Thoughts?
I was playing around with case designs over the vacation, and came up with this...
- Based on the new Kevin Gilmore Dyna-GBF-FET design
- The base is 10" by 12"; room for two Power One HCC24-2.4-A supplies, +/-24V at 2.4A each
- Boards are 2.5" diameter; columns are 6" tall
- Outer supports are 3/16" threaded rod with 1/4" brass tubing over it
- Inner column is 1/2" diameter, but it could be increased to 3/4"
- Inter-stage connections are lined up board-to-board, vertically
- Power and output connections go through the center column
- Heatsinks are not pictured, but Aavid has plenty in the right range (< 16 C/W)
Thoughts?