-
-
Just finished these:) -
Xymordos replied to the thread Home-Made IEMs.This 6mm planar works like a planar (rather than say the Square Planar). But honestly the voice coil design still throws me off as it is...
-
Xymordos replied to the thread Home-Made IEMs.Yeah I think you explained it better than me. It just felt more similar to a DD than a planar to me for some reason.
-
If I had to make up a definition, orthodynamic/planar drivers are electromagnetically driven transducers have traces on a freestanding...
-
Xymordos replied to the thread Home-Made IEMs.Yes, but when normal people take it apart and don't see bar magnets they go nuts lol
-
Extension-wise it is the very best driver I've seen, nothing comes close to it, not RAU, not any of the ESTs or any other planars I've...
-
Xymordos replied to the thread Home-Made IEMs.I think it's just that the construction is somewhere in between the two, or perhaps more similar to a dynamic driver than a planar. It...
-
I have made 2 of above for tunning 4 set of drivers in series and parallel instantly, its really saving a lot of efforts and times to...
-
Xymordos replied to the thread Home-Made IEMs.This works and it sounds very good. I personally always use this design in my configs, you should try it too!
-
That new Quad set-up I was telling yall about is being put out into the wild!
-
Xymordos replied to the thread Home-Made IEMs.I bought a sample batch of 20 or something, and they were pretty badly matched, might be just bad luck for me. The pair that came in the...
-
Xymordos replied to the thread Home-Made IEMs.Huayunxin doesn't seem to have a shop on Taobao it seems... I've bought them factory direct via Alibaba.
-
Xymordos replied to the thread Home-Made IEMs.They are terribly matched, really expensive at RMB50 per piece too. The KZ CRN used them (I think) and the drivers in the iem I got were...
-
So, I just completed a 4 driver configuration using the ferrofluid 38 paired with a 2389D.... HOLY SMOKES!!! I can't reveal the...
-
The insertion depth is also something you need to consider during prototyping electrical and acoustic design - the deeper your CIEMs...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…
