-
-
My small DIY FullSize Headphones. Audeze Sine Headband, AKG N90q(52mm) drivers, mmcx connectors. Full open back design + 2 dampers on... -
I can't believe it's been over 3 months already. I've done a lot of work since the last update, and TL;DR, I scrapped the entire round...
-
Tofty reacted to Ulfar4's post in the thread Yet Another DIY Isodynamic (Planar Magnetic) Headphones with
Like.
Hi All, I have been working on this headphones for some time and I want to share some results. I want to clear from start that I won't... -
Tofty replied to the thread Tofty's DIY Headphones - 3D Printed.That's a really nice design. What resolution are you printing at? That came out so much cleaner looking than my prints have. I'm...
-
Hello, me again. I decided to persevere with the idea of angled drivers for no real reason, and I'm happy to report I finally have...
-
Tofty replied to the thread Tofty's DIY Headphones - 3D Printed.I suppose the benefit of a PLA headband is that even if it only lasts 6 months; you know you can print a replacement and it will cost...
-
Tofty replied to the thread Tofty's DIY Headphones - 3D Printed.Thanks Johannes, The wiring will depend on what type of split cable you plan on using, as to what connections should be made. If the...
-
Tofty replied to the thread Tofty's DIY Headphones - 3D Printed.It's been a while. I bought an old pair of Grado SR125s, but the forks on both sides were either cracked or cracking around the metal...
-
-
Tofty replied to the thread 3D printed headphones.Very Nice. It's good fun, isn't it; making headphones.
-
Holy moly they work, and they actually sound pretty decent even without my putting any damping material in them yet! I can't believe I...
-
Updated baffles with a notch for pads and the drivers and passive radiators: I have no idea if the passive radiators will do...
-
Hi all, I’ve been tinkering with headphones for quite some time and now that I have a 3D printer, I’m taking my first crack at a full...
-
Finished my first headphone stand. Bought metal 3/4 bits and used some wood I had around. If I had taken more care with the wood grain...
-
Printed the screw holes undersized then threaded them with an M3 tap. When I fnally make a "final" version of them, I'll probably use...
-
Tofty replied to the thread Jim's 3D printed headphone designs..Nice job JimbobJr, I like how you've simplified the design and removed everything superfluous. That's the sensible way to build...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…
