I want one of these so bad. Got myself an MT-602 for bedside and TA-22 for main recently, and I'm a fan. This may be in my future. I have some Koss 60ohm drivers, a Senn HD490 that is 150ohm or so, and an LCD-3 which is also over 100ohm that should hopefully work out ok with this.

Hi all, Just wanted to post here since it's been awhile. So I sent my Koss KPH40 to be fixed, which I got back, and got a custom headband "strap" from Etsy for it since the raw metal headband didnt sit well on my head. Also got some red Yaxi pads. While I think the Yaxi pads do affect the...

Tested both external and internal. If this is expected behavior... it's fine, just wondering why when all other balanced to SE amps I've used have always been louder on balanced connections. I understand power is not necessary the causation of amp loudness. Gain levels used matter, but you'd...

Tried from 20ohm to about 150ohms. SE is slightly louder on all.

Quick question, I couldn't find it, but is there a reason the TA-22's balanced output volume is slightly lower than the single ended output? I would assume this amplifier is truly balanced, and wondering if it's just a gain adjustment that makes the volume louder for the single ended even...

SOLD.

Sale pending. That was quick!

Hi all, so for sale I have my very beloved: Schiit Jotunheim 2 (silver) - This has an extra RCA input module...so 2 RCA inputs + XLR rear input Schiit Modius (silver) - The pre-AKM fire Modius with AKM dac chips Pictures have some led dimmers on the on volume knob, and power/source lights. You...

Was testing this myself after not having used Penrose in a long time and had a similar issue. I did the rollback as mentioned above and fixed it, so yes, please email support@audeze.com to be provided with the steps.

Basically my question is whether the volume exceeds line level at a certain volume level setting so I can stay below that.

Guys, quick question. I see some steps for enabling line out mode, but it won't trigger for me. What are the exact steps to enable line out mode. Either way, is there a certain volume level for line level? I essentially want to use my Gryphon as a DAC for my powered Presonus monitors through I...

Ensure it is not your source or ground loop. A typical response we provide since many times it's not the headphone: LCD-XC is a very efficient headphone and the humming you're hearing is most likely a ground loop. This depends on the amplifier and upstream components; some are more sensitive...

Ah I didn't know this. They've improved the virtual surround quite a bit from 6-7 years ago. It's absolutely insane now. I gotta set that GG software back up so I can use it with all my headphones. I had an issue so I uninstalled, and went back to DTS Headphone X.

You can email us at support@audeze.com if you want to get it inspected, and if we deem it out of tolerance, we can get it replaced under warranty, but it is unlikely any replacements will yield different results as some noise is the expectation and we cannot adjust further.

Yes, we are still working on firmware releases. We'll have more to say once it's closer to release.