The issue is with the Chinese manufacturing, the leather is not as nice, the plastic quality is lower, the actual molds themselves aren't set up properly, these driver issues, they just seem less refined. I owned K701s 7 years ago, and they were worlds better in quality. no bubbles in the...

They are, and I will be. It seems from elsewhere I have posted this is a common problem. Especially with the Chinese built AKG. The plastic molds have a lot more "flash", and the plastics aren't mixed properly, giving the inside an uneven appearance. With these being so common, not many...

http://imgur.com/a/UisQ7 Links to the damage in the drivers.

I just recieved my q701's in, and arent very impressed with the build quality at all compared to the k701's I had many years ago. These seem flimsy, the headband seems to be fake leather. And the worst thing is, I take the ear cups off to inspect the build quality, and my right driver has a...

1.4ohms to 3.9 ohms? They are adding a ton of resistance.

Is that copper tape grounded to anything? If it isn't grounded, it cant block anything. I've done my own DIY EMI shields for soundcards before. Made a pad of electrical tape the same size as my soundcard, placed a same size sheet of thick aluminum foil over that, and then arranged pennies in...

If you are getting bitperfect out to your DAC, then it is likely all in your head.

Does anybody know if the obective2 has been o-scope measured while connected to actual headphones? I'm wondering if it can maintain its tight specs while hooked up to the varying load of a headphone and their voicecoil. I'm thinking of picking up a kit or board to make a desktop version.

Anybody know why the buffer bias reading would drop across one channel when hooked up to headphones without sound. The right and ground channel only vary from no load readings by 3mv. while the left channel drops about 20mv. With another set of headphones it is the opposite. Left and ground...

I've been building computers for over a decade and have never encountered any of those problems.   An ATX cable and ATX 12v cable are always required. So full modular has no advantage over semi modular here. A cable should never become faulty. They are physical equipment, they do not fail...

Anybody have the spec sheet for the stock crystal? I'm looking to keep something that fits the stock board. I think all of these clocks being run with such long runs of wire would introduce more problems then they would solve. As PCB's are designed to optimize layout, and having a few cm of...

If the warning of lead just means they use leaded solder, that would be a good thing. Lead free solder isn't as reliable in electronics. Though a warranty reduction could be signs they build quality has dropped, or it could just be harmon trying to maximize profits, warranty services can be...

Well, can't say I've run into this problem with any of the modular power supplies I've owned. Though I stick to the Antec TruePower units, and they physically change the connectors, so that even if one is 2x3, or 2x4 pinouts, they physically can not be inserted into the connectors they are not...

Thanks for that, well it looks like they maybe too a few design ideas from Grado, and a few others, to produce what seems like the headphone Grado should have been making years ago. Really interested in trying to grab a pair.