My Gilmore sounds wonderful with my 600's. It cost me around $600 to build because I spared no expense (and made a few boo-boos).

THIS jig with a good plunge router will give far more perfect circles than anything discussed so far...I've built a lot of speakers even in the <2k in raw parts range. However, for squares, ignore me. Edit again: I used a power jigsaw every day when I was eleven+ ..... *shrug* never had...

Good point. I could make 4' cords myself for $15.71 (plus shipping ) each with Schurter 4781.0100 and Pass & Seymour 5266-X from Newark. http://www.audiotweaks.com/diy/bobcrump_pc/page01.htm

I was under the impression THIS was pretty darn good for well under $100?

I lowered my DC from 50-90mv to >5mv by matching the LED's better and then replacing the servo opamps with brand new ones.

Pretty sure Mark is referring to his source. Too bad my source has a molded cord, and I don't feel like Dremel'ing it.

Quote: Originally posted by Hiker Yes I know it plays DVD-A. Let me clear that up: I wonder how this stacks up against the Philips 963SA despite the fact that the Philips lacks DVD-A. My bad. I thought the Phillips played DVD-A also...just checked again, and it does not! I suppose...

Quote: Originally posted by Hiker I wonder how this stacks up against the Philips 963SA despite the fact that it lacks DVD-A. It plays DVD-A.

Quote: Originally posted by strohmie ...pretty sure your best bet for "giant-killer" interconnects are ones you make yourself. I sure can do that.... there seems to be several schools of thought around cables.... one school is that there is 'magic' beyond the materials put into...

Anyone have any opinions on the cables from Heartland cables? Specifically, the interconnects they offer with the new bullet plugs: http://www.heartlandcables.com/ .... They are priced fairly close to the cost of the materials that go into them, unlike most. Another possibility...

What about this article?? MP3 VS CD

See below a pic of the guts of this player. Anyone see some good tweaks? Replacing caps, shielding, that kind of stuff.

I've fixed the 240 ohm resistor. The file is in Express PCB format. (www.expresspcb.com).

I can't answer your question, but I would probably go for these instead, and get the correct value: http://www.partsconnexion.com/catalo.../sheet021.html (Use the arrow and go all the way to the right to the 'VISHAY-Draloric' tab)

Good eye. Thanks. Note: I have dropped this project for now, I am enjoying my Gilmore too much to build more atm. Anyone that wants the .pcb file to play with just PM me with an email. (Though I'll warn you, getting small lots made is outragously expensive!)