-
-
Balazar replied to the thread RMAF: RIP :-(.I attended it in 2019. It was quite an amazing event. I'm disappointed and at the same time not surprised. They sent an email saying...
-
Balazar replied to the thread "Open Alpha" T50 3D printed headphone project from MrSpeakers.M3 set screws work well. Length is up to you. M3x8 or M3x10 seem to be have been the popular choices. You may also want to run an m3...
-
Balazar replied to the thread Fostex T50RP Incremental Mods and Measurements.I'm under the impression that the original alpha dogs had modified diaphragms. That is something that no one on this forum has attempted...
-
Balazar reacted to musicfan145's post in the thread "Open Alpha" T50 3D printed headphone project from MrSpeakers with Like.I created a modified version of the original bass port design, which used a 2.5mm connector. I believe a 3.5mm connector would work as...
-
Balazar replied to the thread "Open Alpha" T50 3D printed headphone project from MrSpeakers.Wait, This is the link. You need OmNomNomagon's remix
-
Balazar replied to the thread "Open Alpha" T50 3D printed headphone project from MrSpeakers.You can use the modded cups that I did with adjustable bass ports.
-
Balazar replied to the thread What's your favorite Fostex T50rp mod?.The mods can go as far as you want to take them, anything from a little tweaking with pad rolling, to complete transformation. I...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…