Thanks for the info! I also found a VJJB N1 bluetooth cable that looks like it might fit. (I don't really like bluetooth for listening but its a nice option for phone calls.) https://www.ebay.com/itm/80CM-Practical-Bluetooth-5-0-Cable-DC-Interface-VJJB-N1-Headphone-Cable-Device/293133323479

Does anyone know if the Audio-Technica A2DC cables will work the Dubliz Enhanced?

I got HD25 velour pads on them.  Sound is a touch more balanced.  I've been burning them in for the last week and they sound detailed and neutral now.  I wish the soundstage was a little wider.   As far as comfort goes, the velour is better but because they sit on the ear, they start to get...

I've been looking for some low profile closed headphones for on the go. I recently got the JVC HA-S500.  After some burn-in they've balanced out & sound pretty good.   The detail is pretty good but due to being closed type, they sound a little compressed.    I was wondering if anyone has...

Ordered the HA-S500 off Amazon and got them in 3 days from Japan to California. I didn't expect so soon but I'm happy.     I took a break from Head-Fi and haven't posted here in a long time. I have been lurking and watching reviews as new products release.  I was spending a lot of time and...

PortaPro, SportaPro and KSC35 are all the same driver.  SportaPro cost less.   KSC75 are different drivers (titanium coating) but the clips fit.  However, I've found them to snap in a little looser with the SportaPro/PortaPro drivers.   With the cheap parts express band they snap in...

You're looking for over the ear closed headphones that don't leak? Not in ear monitors, right?   The Denon 2k are one of my favorite closed style headphones.  I listen to my Denon 2k on my MacBook Air without needing an amp.  On the iPod you may need an amp depending on how loud you listen...

You may want to try the DIY section but I've re-cabled my Senn HD600s with Mogami and they sound fabulous.

Thanks. This is exactly the info i needed.   The question I have now is if the mic (depending on the type) needs the 5v or not for connectivity to the iPhone.  

Did some more searching and didn't get a definitive answer but I think i figured out the mic is mono, mic signal is tip, ring isn't connected, sleeve is ground on the 3.5 TRS female and shares the ground ring on the 4 pole TRRS male side.   Male 4-pole connector wiring Tip = left signal...

Greetings!   I have a gaming headset I like with 2x 3.5mm TRS connectors (one for the headphones, one for the mic).  I want to use it with my iPhone for long calls I've found the Headset Buddy connector but want an angled 4 pole connector.  I've build a bunch of my own 3.5 cables and...

I've heard of people having problems with strain relief and the cable splitting at the ends.  I've had mine for a couple of years and I have not had the problem.  I'm pretty careful and don't pull them out from the cable.

I owned the M2 briefly. X10 are a world better in all ways. Bass is nice and deep without being muddy.  Some have said they're bloated but I find the base just right.  Clarity of the mids is good and no sign of sharp symbilance in the highs.  You really can't go wrong for the Amazon price right now.

The Shure MPA-3c has a 3.5mm jack with a build in mic so you can plug your own headphones in and use it with your iPhone.    I've rewired a few headphones to be short (below the chin with a 3.5mm plug) so I can plug in the Mic adaptor to my iPhone.  I've tried all of the other mic adaptors...

Quote: I didn't find the HJE900 signature anything like the Turbine. In fact, I found the HJE900 treble to be very fatiguing to the point I couldn't stand it. I can see the appeal of the Turbine. I'm not saying the Turbine is perfect but I found the soundstage to be a bit larger than a...