You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
-
-
2359glenn replied to the thread 2359glenn | studio.Take a picture of the underside and send it to me.
-
2359glenn replied to the thread 2359glenn | studio.I will send you a PM
-
2359glenn replied to the thread 2359glenn | studio.Output impedance about 60 ohms. Tube rectification ether mercury vapor rectifiers 866 or 3DG4,5AU4 or 5CU4 rectifiers. The mercury vapor...
-
2359glenn replied to the thread 2359glenn | studio.The 5CU4 is a great tube low voltage drop high current. Most amps can't use it but yours can. A bit hard to find though. Glenn
-
2359glenn replied to the thread 2359glenn | studio.Glad to talk to you guys again. Have to build some amps to stop me from going crazy. In hospital for months takes a toll. Being bed...
-
2359glenn replied to the thread 2359glenn | studio.5CU4 is a great rectifier tube for the OTL but draws over 3amps filament current might overheat the transformer in other amps.
-
2359glenn replied to the thread 2359glenn | studio.I will get that amp back to you. My problem now is I am to feeble to pick the amp up in the box. I will make no more amps with 3...
-
2359glenn replied to the thread 2359glenn | studio.Hi Have you taken the bottom off? Might have a bad plate resistors on the 6SN7. At a point I thought that boutique parts would be...
-
2359glenn replied to the thread 2359glenn | studio.Hi All I am back somewhat feeble now but plan on working on amps again in a limited amount. Designing a OTL amp that will drive the...
-
2359glenn replied to the thread L0rdGwyn's DIY Audio.Hi Everybody Happy Thanksgiving Been gone for awhile due to health issues Have a great weekend
-
2359glenn replied to the thread 2359glenn | studio.Armacost Lighting Quick Connect Terminal Block (3-Pack)-920030 - The Home Depot
-
2359glenn replied to the thread 2359glenn | studio.It only hurts for a second ! Try some of these cut one off then cut the wire stick one wire in one side one in the other ant tighten the...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…