2359glenn's latest activity
-
2359glenn replied to the thread 2359glenn | studio.That should work no connection to the screen grid. Just remember that it has CCS set for the EL3N with LED bias on the cathode. Try it... -
2359glenn replied to the thread L0rdGwyn's DIY Audio.Did you buy that short piece? I usually have to buy it in 100ft roles don't matter I use it all.
-
2359glenn replied to the thread L0rdGwyn's DIY Audio.Craziness.
-
2359glenn replied to the thread L0rdGwyn's DIY Audio.Tuff wire to work with I use it at work to feed power and signals to sensors. High power frequency drives with a 480 volt 50amp square...
-
2359glenn replied to the thread 2359glenn | studio.Bad solder connection in one of the pins is most likely the cause
-
2359glenn replied to the thread 2359glenn | studio.Back from a week in Pennsylvania buying used machines from company's that closed down. And dismantling them so they can fit in a truck...
-
2359glenn replied to the thread 2359glenn | studio.Trying to get back to normal building but this new job is killing my life. These 50 to 60 year old machines are killing me at least the...
-
2359glenn replied to the thread L0rdGwyn's DIY Audio.You have a problem I have been doing this for 50 years.
-
Since I'm operating rather far off the beaten path, I'm not sure if there is much interest in my current roll, but thought I'd share...
-
Thanks, @Zachik , I appreciate it. Just a quick update on the 801A A2 amplifier, I have been working on it in the background...
-
So, I thought it was going to be a couple weeks until I had the powder coating equipment based on an email I received, turns out it is...
-
I have one more result to share. For the above, I included a film cap in the feedback loop to block DC from the 801A plate. However, I...
-
2359glenn replied to the thread L0rdGwyn's DIY Audio.The 10Y>300B sounds great had them for 16 years now. But I don't think I would make this direct coupled amp for anyone as the B+ voltage...
-
2359glenn replied to the thread L0rdGwyn's DIY Audio.The EL3N is a really good sounding tube also. But to really use it in a spud amp really needs a input transformer to boost the input...
-
2359glenn replied to the thread L0rdGwyn's DIY Audio.Not that unreasonable I paid allot more then that for 300Bs. Might have to do something about that cathode resistor bypass capacitor and...
