-
-
Mmanishex posted a comment on classifieds listing Lavricables Grand for Sony MDR-Z1R, MDR-Z7(M2).PM sent
-
Mmanishex posted a comment on classifieds listing Norne Audio "Nameless" Silver 21 AWG 8 core cable (4pin mini xlr to 6.33 single ended).Pm sent
-
Mmanishex posted a comment on classifieds listing Gustard R26 DAC & Streamer R2R.price drop
-
MYes, I would start with a 6 kHz HF shelf and adjust a few dB up or down to taste. A 65,536 tap FIR filter has more than enough...
-
Mmanishex replied to the thread Accurate Sound convolution filters.Any recommendations on a good basis for a high frequency shelf? One from 6khz or 10khz? Would we benefit from having more Taps on the...
-
M@GoldenOne , I agree with everything you are saying, however, I think you may have overlooked the high frequency response limit of the...
-
Mmanishex reacted to GoldenSound's post in the thread T+A HiFi - DAC 200 - Official Discussion Thread with Like.Not quite. The PCM1795 DAC uses Burr Brown's 'advance segment' architecture. The simplest way to explain this is that the top 6 bits...
-
Mmanishex reacted to Soundguy123's post in the thread T+A HiFi - DAC 200 - Official Discussion Thread with Like.My statement is entirely accurate if you examine my statement carefully. I did not say the PCM signal input has the exact same path as...
-
Mmanishex replied to the thread T+A HiFi - DAC 200 - Official Discussion Thread.Depends on what dac you have as some dacs have poor dsd implementation. I think the best results come from discrete dsd dacs that can do...
-
Mmanishex replied to the thread T+A HiFi - DAC 200 - Official Discussion Thread.I think most of us are converting pcm to dsd via hqplayer (eg 48khz 16 bit to 49mhz 1 bit). Hqplayer can stream qobuz directly or used...
-
Mmanishex replied to the thread T+A HiFi - DAC 200 - Official Discussion Thread.It paira with susvara amazingly well. It's not a bright dac but very revealing at the top, I just add 3-4 db in the bass and it fill out...
-
Mmanishex replied to the thread T+A HiFi - DAC 200 - Official Discussion Thread.Dac200 DSD out is 4.4v and may is 2.9v so that should be taken into consideration when comparing dsd. Pcm may is 5.8v and dac200 is 5v...
-
Mmanishex replied to the thread Holo Audio Spring R2R DAC.At 100 percent without preamp it would be 2.9v and with preamp it would be 5.8v
-
Mmanishex replied to the thread Holo Audio Spring R2R DAC.Oh I only had -3, I completely forgot holo dacs need - 6 since I only recently got the spring. If that's the case then the 2.9v out will...
-
Mmanishex replied to the thread Holo Audio Spring R2R DAC.No rca, the spring 3 without preamp and the may output 2.9v xlr on dsd and 5.8v with pcm. The spring with pre amp can go higher than...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…