jamato8
Headphoneus Supremus
On the optical cables my measurements are just the cable but not the connector ends, which of course also add length. With the shortest I mention there is just enough length for a U and about 2cm from tip to tip on the U. this would allow for a iRiver or like device sitting on the D1. If you get it in toslink to toslink and get two of the right angle adapters, which work very well, you can have a short U not projecting out but lying along side of the ends of the D1 and iRiver. Or you could also get a mini to toslink (I got both) in the shorter length and have the U extending on out from the back of the units. I wish now I had gotten a tos to tos and ppurchased two 90 degree adapters. I also go the longer length in both toslink and mini to allow for a little more separation, though not much, or a different component with a toslink or mini out to the mini in of the D1. There, how is that. :^)
The shortest length, end to end as specified by Sys. Concept is 9.5cm and the longer one I got is 13.5 from one end to the other end of the entire optical cable including ends.
The shortest length, end to end as specified by Sys. Concept is 9.5cm and the longer one I got is 13.5 from one end to the other end of the entire optical cable including ends.