Kuja
Head-Fier
- Joined
- Jan 22, 2002
- Posts
- 67
- Likes
- 0
I'm stuck with an Audigy 2 until I have the cash to upgrade, but in the meantime, I have an A2 ZS outputting via analogue to a Headroom TAH with ER-4S.
My problem is that it seems I'm barely using the amp, or perhaps even further screwing the quality by reducing the volume using the amp
If I set wave/master to 100%, the A2 in itself is sufficient to drive my Etys well beyond listening volumes, so with the amp connected, wave/master set to 100% and using the amp to adjust volume to an appropriate level, I'm actually reducing the volume with the amp controls.
As far as I'm aware you're meant to set wave/master to 100% to avoid loss of quality, but to let the card amp (?) the signal to beyond what I need then reduce it with the amp doesn't seem right at all
What should I do?
Btw I'm using kx drivers so I can adjust master, wave as well as the gain on the individual outputs.
My problem is that it seems I'm barely using the amp, or perhaps even further screwing the quality by reducing the volume using the amp
If I set wave/master to 100%, the A2 in itself is sufficient to drive my Etys well beyond listening volumes, so with the amp connected, wave/master set to 100% and using the amp to adjust volume to an appropriate level, I'm actually reducing the volume with the amp controls.
As far as I'm aware you're meant to set wave/master to 100% to avoid loss of quality, but to let the card amp (?) the signal to beyond what I need then reduce it with the amp doesn't seem right at all
What should I do?
Btw I'm using kx drivers so I can adjust master, wave as well as the gain on the individual outputs.