DolbyR
100+ Head-Fier
- Joined
- Sep 13, 2005
- Posts
- 220
- Likes
- 10
Well... I guess my problem with the left channel buzz must definitely be from the cheap china-pot...if i turn it to the absolute maximum, then it completely disappears and the channels are more even then too. Probably for now, I'll just set it directly on the board to function without a pot and use the volumer control from the laptop, atleast until I get the AlienDAC, then I'll see if to get an Alps or if to get somekind of stepped attenuator.
Probably I could also get rid of the hum by adding the output resistors, the RP21s are afterall quite low impedance.
If I remove the pot, should I just connect the inputs and outputs with jumper wires, or should I solder a resistor instead between the INs and OUTs? If my port is the problem, then removing the pot should prove it.
Any comments?
Probably I could also get rid of the hum by adding the output resistors, the RP21s are afterall quite low impedance.
If I remove the pot, should I just connect the inputs and outputs with jumper wires, or should I solder a resistor instead between the INs and OUTs? If my port is the problem, then removing the pot should prove it.
Any comments?