[peculiarism]

I have a pair of ad700's and i need to rewire the left driver. Only I'm not sure which wires go where...

Baiscall there are the three wires from the jack (white blue and red), and the red and gold tinsel wires fed through the frame of the cans

Not sure where to solder these in relation to the solder points on the L driver?

Any help would be greatly appreciated.

Thanks in advance.  

 

[peculiarism]

bump!
 
still havn't figured this out
 
Anyone have any experience with ad700 wiring please?

 

[nullstring]

You could always open up the other side.
 
The drivers are identical and you should be able to figure out which one is ground
 

 

[nikongod]

or listen

 

[DannyBuoy]

I have a pair of these and can open them up and take pics for you. They are at my office though and will have to wait until tomorrow.
PM me if you need the pics and I will do in the morning when I get in (Pacific Time).

 

[nosaj03]

I would open up the other can and use a DMM to test which side is what. If the stock cable is still attached then I would test the channels by the position on the jack.

 

[jschristian44]

have you figured out which is which?  the ground wires are self explanatory, but im not sure why the signal wires are soldered in the same place and the white is free.  can someone explain this?