e1cie1o
New Head-Fier
- Joined
- Jul 25, 2009
- Posts
- 11
- Likes
- 0
So I just ordered some JH10X3s from JH Audio and am most likely going to build a Mini^3 for use with them and either my iPhone4 or iPod 5G. Any recommendations on where to start with the gain on the Mini^3? I believe the default for the Mini^3 is a gain of 5x, but with such low impedance IEMs (18ohm), do you think I should go with 3x or 2x? I can always switch out the resistors later to change if I'm not happy with the original, but I figure it wouldn't hurt to start lower either.
Any input is appreciated!
Any input is appreciated!