1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.

    Dismiss Notice

Klipsch Image S4i II Wiring Help

  1. lasraik
    I recently bought a pair of Klipsch Image S4i headphones on eBay that had a bad headphone jack.  I picked up a few TRSS replacement jacks, with the help of this website I found this:
    And also found this helpful picture
    So the problem I'm running into is I can't get the remote to work.  Sound comes in great on both left and right sides, but no luck getting the remote to operate.  I've tried a few different combinations but just can't seem to get it to work.  This is first time I've fixed a TRSS headphone but I've done lots of reading and searching and just can't find what I'm doing wrong, starting to get frustrated.  Any help would be greatly appreciated!
    Edit: OK after cutting the cable and starting all over again, the above colors are correct.  Not sure what I was doing wrong with the wires but it works now.
    There is a strand with a white coated wire and a green and red wire wrapped around it.  I unwrapped those three wires and wrapped the red strands with the red cable for the right side and the green strands with the green cable.  This was a bit tedious so I used a small pair of needle nose pliers to get the strands apart.  Then used the copper cable for the ground (3) and the white cable tinned the wire a bit to get the coating off and soldered that to the sleeve.  This did it, they work great now.
    Hope this helps someone else who runs into the same problem.
  2. Feloemeche
    I did it as the first diagram and as your last edit and it worked. Thanks!
    lasraik likes this.

Share This Page