thapchild
Head-Fier
- Joined
- Oct 9, 2012
- Posts
- 57
- Likes
- 16
So, I bought my JH-16 back in October of '12, and the very first day I received them i replaced the cable with the cable from my TF10vi. I have a few pictures of them with the original cable. I'm pretty sure the cables had never been taken out in those pictures, and they show the dots facing up/back. However I'm not 100% sure the cables weren't remove prior. If they were I'm sure I would have put them back the way they came out.
On the pictures the dots face back/up when inserted in your ear. I confirmed this with Angie @ JH. She said that the dot side was the positive side of the cable and should be facing up/back.
Sounds good... I tested with my multimeter and the pins that are on the dot side are in-fact positive. Awesome... right? welll.... not so much.
If I look at the wiring inside my IEM (they are transparent) I see that the positive left pin plugs into the "red" internal wire inside the IEM. Red has always been positive in every speaker application I've ever seen my entire life. So all is good on the left side in my opinion... But on the RIGHT IEM, the positive wire pin plugs into the green wire inside the IEM, and the ground pin on the wire plugs into the red wire inside the IEM... this is backwards from what I'd expect. Red is always positive... ground plugging into red?... Did my IEMs get wired backwards?
So to better understand what i'm saying i made a mess of a picture in photoshop.
Can someone with clear JH-16 please confirm your red/green wiring on the inside? and confirm how they shipped with the cable dot orientation?
Mine are freaq-phase, if that makes a difference.
Here's my mess of a pic: This is a pic of the RIGHT iem, inserted in my ear, with the green wire on top, and red on bottom.
On the pictures the dots face back/up when inserted in your ear. I confirmed this with Angie @ JH. She said that the dot side was the positive side of the cable and should be facing up/back.
Sounds good... I tested with my multimeter and the pins that are on the dot side are in-fact positive. Awesome... right? welll.... not so much.
If I look at the wiring inside my IEM (they are transparent) I see that the positive left pin plugs into the "red" internal wire inside the IEM. Red has always been positive in every speaker application I've ever seen my entire life. So all is good on the left side in my opinion... But on the RIGHT IEM, the positive wire pin plugs into the green wire inside the IEM, and the ground pin on the wire plugs into the red wire inside the IEM... this is backwards from what I'd expect. Red is always positive... ground plugging into red?... Did my IEMs get wired backwards?
So to better understand what i'm saying i made a mess of a picture in photoshop.
Can someone with clear JH-16 please confirm your red/green wiring on the inside? and confirm how they shipped with the cable dot orientation?
Mine are freaq-phase, if that makes a difference.
Here's my mess of a pic: This is a pic of the RIGHT iem, inserted in my ear, with the green wire on top, and red on bottom.