streetdragon
Headphoneus Supremus
- Joined
- Dec 29, 2011
- Posts
- 2,911
- Likes
- 158
Quote:
http://www.youtube.com/watch?v=r8i_ZGHHhuQ
this video is really good, as you can see in the video, just support the under part of the pad and pull outwards, the part where you should be most careful is unscrewing the driver, there is a hole in the center where the screw might fall in or you might poke the driver with the screw driver. putting the pad back on is really easy, just push it at the inner part of the pad rim firmly till a few clicks sounds are observed, and done!
I am really worried about removing the valour pads, do they clip on? how are they attatched? Also when you put them back on did they look exactly as they did before you took them off? Do I just take them off, remove the 3 screws then carefully remove the foam strip?
http://www.youtube.com/watch?v=r8i_ZGHHhuQ
this video is really good, as you can see in the video, just support the under part of the pad and pull outwards, the part where you should be most careful is unscrewing the driver, there is a hole in the center where the screw might fall in or you might poke the driver with the screw driver. putting the pad back on is really easy, just push it at the inner part of the pad rim firmly till a few clicks sounds are observed, and done!