hikari
New Head-Fier
- Joined
- Apr 25, 2012
- Posts
- 25
- Likes
- 10
Good day guys.
I'm looking to make an Impedance adaptor for my IEM's (Monster Miles davis trumpets)
I can't find any info online about the specs of these IEM's
I hooked up my Fluke meter and tested my Q701's and gave me a reading of 60ohms I know by there specs its 62ohms so I can see this can be off by 2ohms
I hooked up the IEM's to the meter and got 1.8ohms I will assume they are 2ohms ( would love if anyone could enlighten me on the true specs of these)
Ok that being said I would like to hook them up so my SCHIIT LYR amp the spec's on the output is 8-600ohms
-- So with this information would it be safe to say I would need a 6ohm resistor for each side (left and right)
Please enlighten me on any of this. I welcome any form of education....
Thanks
I'm looking to make an Impedance adaptor for my IEM's (Monster Miles davis trumpets)
I can't find any info online about the specs of these IEM's
I hooked up my Fluke meter and tested my Q701's and gave me a reading of 60ohms I know by there specs its 62ohms so I can see this can be off by 2ohms
I hooked up the IEM's to the meter and got 1.8ohms I will assume they are 2ohms ( would love if anyone could enlighten me on the true specs of these)
Ok that being said I would like to hook them up so my SCHIIT LYR amp the spec's on the output is 8-600ohms
-- So with this information would it be safe to say I would need a 6ohm resistor for each side (left and right)
Please enlighten me on any of this. I welcome any form of education....
Thanks