ShinyFalcon
500+ Head-Fier
- Joined
- Dec 29, 2006
- Posts
- 877
- Likes
- 11
Pins 1 and 3 are connected probably not within U6D but from the traces on the PCB. You can verify it by looking at the schematics. Chances are, you didn't burn it yet.
As for pin 2, that is connected to ground.
If it helps, I once bridged 1 and 2 on a similar voltage regulator, and the chip got hot enough to smoke (maybe it smoked the flux that was stuck nearby), extremely hot to touch. That chip still works properly!
As for pin 2, that is connected to ground.
If it helps, I once bridged 1 and 2 on a similar voltage regulator, and the chip got hot enough to smoke (maybe it smoked the flux that was stuck nearby), extremely hot to touch. That chip still works properly!