Fostex HP-P1 Headphone Amp/DAC
Feb 25, 2011 at 8:14 PM Thread Starter Post #1 of 12

sulvaat

New Head-Fier
Joined
May 7, 2010
Posts
46
Likes
10
I don't know if this was talked about before but after a quick search I could not find any real info on it.
 
I found this while perusing the Fostex website. http://www.fostex.jp/personal/products/HP-P1?tab=spec
 


Specs
● ヘッドフォン出力端子( ステレオミニジャック) 
最大出力:80mW + 80mW (32 Ω負荷) 
適合負荷インピーダンス:16 Ω以上 
周波数特性:20Hz~20kHz ± 0.3dB(32 Ω負荷、80mW 出力時) 
THD+N:0.01% 以下(1kHz、32 Ω負荷50mW 出力時)
● [LINE OUT] 出力端子( ステレオミニジャック)
最大出力レベル:2Vrms( 0DBFS )
周波数特性:20Hz~20kHz ± 0.3dB
THD+N:0.002% 以下( 0DBFS )
● アナログ入力端子 ( ステレオミニジャック)最大入力:約3Vrms
● [S/PDIF] 出力端子( オプティカル)S/PDIF フォーマット(IEC 60958-3, JEITA CPR-1205)
● Dock ケーブル用USB コネクタ(iPod/iPhone 接続用):USB A-Type
● [DC-IN] 端子:USB Mini B-Type
● [FILTER] 切替スイッチ:シャープロールオフ・フィルター/ミニマムディレイ・フィルター
● 電源:内蔵リチウムイオン電池
● 充電時間:約5時間(HP-P1電源OFF時)
● 連続動作時間:約7時間(iPod装着、ヘッドフォンアウト32Ω 常温時)
● 外形寸法:75( 幅) x 25( 高さ、足含まず)x 130( 奥行き、突起物を含む)mm
● 重量:約260g
● 付属品:DockコネクタUSBケーブル、充電用USBケーブル、キャリングケース、取扱説明書
 
The website mentions that it is 65,000 yen which is around 750USD, pretty crazy.
 
Feb 27, 2011 at 1:58 AM Post #5 of 12
there's definitely another thread about this somewhere, but yeah, that price is outrageous.
 
edit:
 
http://www.head-fi.org/forum/thread/486155/fostex-to-release-revolutionary-dac-amp-combo
 
it was added at the end of this thread.
 
Oct 4, 2011 at 3:23 PM Post #6 of 12
I have just got this not long ago from the Fostex distributor in Singapore (I am a Malaysian). And I must say, this bad boys are good! but i have one question though. Does the line out on this FULLY bypass the internal amp? (plan on having a shoot off between CLAS and the HP-P1). And what is Jitter correction?
 
Oct 5, 2011 at 6:03 AM Post #7 of 12
I have just received my amp today however when I plug my 80 GB classic iPod in all I get is the message it's ok to disconnect?

I cannot operate the iPod unless I disconnect it from the amp! Help. any suggestions ?

I have emailed Fostex direct, I have not tried another iPod yet?

Thank you
 
Oct 5, 2011 at 8:12 AM Post #8 of 12
 
From fostex manual, you can use hp-p1 as dac with:
 
Touch 2, 3, 4 G
iPod classic (so 6G and newer)
iPod nano 4, 5, 6 G
iPhone 3G, 3GS, 4
 
And there have been successful reports in the Fostex main report about iPads too.
 
Oct 5, 2011 at 9:45 AM Post #9 of 12
The iPad2 works with my HP-P1.
 
Nov 26, 2011 at 11:38 PM Post #10 of 12
I am having popping noise from my HP-P1 (both line out and headphone outs), anyone else experiencing the same problem? What should i do?
 
Nov 27, 2011 at 12:10 PM Post #12 of 12


Quote:
You should reboot your iPod.



Yea, hard resetted it once and it didnt work. the problem was fixed after i did it several times. Happened after i updated to iOS 5.01
 

Users who are viewing this thread

Back
Top