Frazo
New Head-Fier
- Joined
- Nov 28, 2011
- Posts
- 6
- Likes
- 0
Hey people,
-New to the forum and without much audio knowlege or experience i was wondering if a Focusrite Saffire 40 interface had enough juice to properly drive my headphones. (Beyerdynamic DT 880 pro 250ohm)
I am planning on buying the interface to help build my recording gear. i was hoping this interface would "kill two birds with one stone" and i wouldn't have to buy a headphone amp also, the amp being a JDS labs objective 2 amp.
I have included the specs of the headphone outs from the Focusrite Saffire 40, this information comes from the Focusrite webpage. unfortunately i am not sure how to read this information.
Any help is greatly appreciated!
-Not sure if any of you have hear of this but this is a cool article!(hearing restored in mammals)
http://hms.harvard.edu/news/hearing-restored-after-noise-damage-1-9-13
-New to the forum and without much audio knowlege or experience i was wondering if a Focusrite Saffire 40 interface had enough juice to properly drive my headphones. (Beyerdynamic DT 880 pro 250ohm)
I am planning on buying the interface to help build my recording gear. i was hoping this interface would "kill two birds with one stone" and i wouldn't have to buy a headphone amp also, the amp being a JDS labs objective 2 amp.
I have included the specs of the headphone outs from the Focusrite Saffire 40, this information comes from the Focusrite webpage. unfortunately i am not sure how to read this information.
Headphone Outputs
- Frequency Response 20Hz-20KHz +/- 0.1dB
- SNR 109dB "A"
- DNR 109dB "A"
- Maximum Output into 32R +12.4dBu (+10.2dBV)
- Power into 32R 250mW
- Output Impedance < 7Ohms
- Load Impedance > 24Ohms
Any help is greatly appreciated!
-Not sure if any of you have hear of this but this is a cool article!(hearing restored in mammals)
http://hms.harvard.edu/news/hearing-restored-after-noise-damage-1-9-13