[jose205]

How big of an improvement is the BTR7 over the earstudio es100?

 

[parnass]

is there any way to save EG settings in the control app?
if I have set the eg values in the app as "custom1" - after a new pairing the settings disappear.

 

[C_Lindbergh]

Just received it! Fantastic device. Just a shame that there isn't a scroll wheel like on the IFi go blu ^^.

Also i don't understand why next track is on the same button as Volume down, shouldn't Vol up match with next track and Vol down with previous?

Also please release the case in genuine leather!

 

[LoryWiv]

Considering upgrading my BTR5 to BTR7 for use with my current facorite IEM, Empire ears ESR MKII. However, BTR7 has output impedance of BAL＜2.8Ω（32Ω loaded) and recommended headphone pairings are 16Ω impedance and above. ESR MKII impedance is 3.9Ω. I know sometimes numbers don't tell the whole story and hoping someone has experience with this or similar combination of BTR7 running balanced out to a very low impedance IEM. Thanks for any info.!

 

[FiiO]

is there any way to save EG settings in the control app?
if I have set the eg values in the app as "custom1" - after a new pairing the settings disappear.

Dear friend,

Please check whether the APP version and the firmware version of your BTR7 is the latest one?
Download link: https://forum.fiio.com/firmwareDown.do

Best regards

 

[FiiO]

Just received it! Fantastic device. Just a shame that there isn't a scroll wheel like on the IFi go blu ^^.

Also i don't understand why next track is on the same button as Volume down, shouldn't Vol up match with next track and Vol down with previous?

Also please release the case in genuine leather!

Dear friend,

Since volume up is in the upper position, so we set volume up button for pre song.
But we will report your feedback to the engineer for assessing first.

Best regards

 

[parnass]

Dear friend,

Please check whether the APP version and the firmware version of your BTR7 is the latest one?
Download link: https://forum.fiio.com/firmwareDown.do

Best regards

thank you - its version V1.88 (the app version is from yesterday's app store - so i suppose the latest) //i dont see any "save" button in EG on app//

 

[sunster77]

How to remove the 60% volume cap on the BTR7?

 

[theElk]

How to remove the 60% volume cap on the BTR7?

It's not a 60% cap. The Unit has 60 steps in its Volumesettings (each Step is 1.6% volume increase).
If the maximum Volume (60) in High gain isn't enough, you can try boost balance mode (if you have a balanced connector on your Headphone).
But you will not be able to see a higher number as 60 on the volume setting.

If this doesn't reach your needs, you can use the BTR7 as a line out into a topping nx7 (high gain, vol. 54 for the 1.4v rms for nx7 at high gain, or 58 in high gain vor 2v rms for any line in)

 

[domq422]

How to remove the 60% volume cap on the BTR7?

I am very curious which headphones you’re currently trying to drive at 100% volume and it still not being enough

 

[Andrew_WOT]

60 units = 100%, not sure why odd number, but it's maxed out at 60.

 

[EdgeDC]

60 units = 100%, not sure why odd number, but it's maxed out at 60.

My guess is that it has a digital potentiometer that has 60 steps.

 

[stenog]

I am very curious which headphones you’re currently trying to drive at 100% volume and it still not being enough

Maybe Hifiman Susvara single end in low gain..

Though I haven't tried it so I don't know.

 

[C_Lindbergh]

Can't seem to use Wireless charghing when the device is off...

 

[LoryWiv]

Can't seem to use Wireless charghing when the device is off...

Deleted