Feliks Audio ENVY

[incredulousity]

It would be nicer if the Woo adapters had the wire exit a cm higher.

 

[1Audiophool]

The last one is the adapter I tore the insulation on
Just waiting on the Elrogs and socket savers. Then it’s time to save for a Dac….if I can control my tube gathering!!!

 

[incredulousity]

Cough-May KTE-cough

Envy likes it.

 

[ColSaulTigh]

The last one is the adapter I tore the insulation on
Just waiting on the Elrogs and socket savers. Then it’s time to save for a Dac….if I can control my tube gathering!!!

Mighty fine tube collection there! Sucks about the adapter not fitting properly - had no idea the Envy had such tight tolerances...

 

[1Audiophool]

Cough-May KTE-cough

Envy likes it.

That is the plan. Would really like to hear a Wavedream/light to compare but that’s unlikely. I’d want a balanced Wavedream anyway and that’s above my budget. Plus I probably want a Bliss now too lol…does it ever end (rhetorical…I know the answer unfortunately)

 

[incredulousity]

That is the plan. Would really like to hear a Wavedream/light to compare but that’s unlikely. I’d want a balanced Wavedream anyway and that’s above my budget. Plus I probably want a Bliss now too lol…does it ever end (rhetorical…I know the answer unfortunately)

I ordered Bliss

Where in Oregon are you?

 

[jonathan c]

Mighty fine tube collection there! Sucks about the adapter not fitting properly - had no idea the Envy had such tight tolerances...

NV = no variance ? ….

 

[Arcamera]

That's some pretty cool art/mat you have under the tubes, 1Audiophool.

 

[1Audiophool]

I ordered Bliss

Where in Oregon are you?

Medford

 

[1Audiophool]

That's some pretty cool art/mat you have under the tubes, 1Audiophool.

Thanks, got it from Drop

 

[incredulousity]

Medford

Cool. I’m in Coos Bay.

 

[nwavesailor]

The last one is the adapter I tore the insulation on
Just waiting on the Elrogs and socket savers. Then it’s time to save for a Dac….if I can control my tube gathering!!!

How are you for soldering? It may not be necessary but if you remove the top anode cap and slide a short section of black heat shrink tubing down the wire, it would cover the wire abrasion and blend in nicely.

I did that with my adapters a few years ago when I noticed the wire getting mashed in a socket of another amp.

 

[1Audiophool]

Cool. I’m in Coos Bay.

Nice, we’re practically neighbors!

 

[1Audiophool]

How are you for soldering? It may not be necessary but if you remove the top anode cap and slide a short section of black heat shrink tubing down the wire, it would cover the wire abrasion and blend in nicely.

I did that with my adapters a few years ago when I noticed the wire getting mashed in a socket of another amp.

That’s a good idea

 

[1Audiophool]

Mighty fine tube collection there! Sucks about the adapter not fitting properly - had no idea the Envy had such tight tolerances...

Well, I have you to thank for suggestions and hooking me up with the Tung-sol. You and @paradoxper have been super helpful. I appreciate it!
Still keeping my eye out for those 1578’s