perry753
New Head-Fier
- Joined
- Dec 11, 2010
- Posts
- 7
- Likes
- 1
Can anyone explain how we can use this as a DAC-only? Do we plug in 3.5<->3.5 from the back of the E10 to our amp?
Will the Fiio E10 have enought power for any headphone?
Just finish listen E10 for almost an hour. Very clean and spacious sound. The amp section is very similar to E11 (obviously as both use the same opamp), but E10 sounds just a tiny bit more crisp. Plenty of power around and should driver anything under 150ohm with ease. I don't have any headphone above 150ohm so I can't say for sure, but I would imagine most headphone under 300ohm with decent sensitivity shouldn't be any problem for E10. For example, RE0 is quite loud with 1.5 / 8 on the volume pot on high gain. The only issue I found on E10 so far is on the gain marking, the High / Low markings are on the wrong sides. Other than that, everything works wonderfully. I'll do a review on it compared to uDAC later on.
Yes, any headphone in the whole world!!!!
Will the Fiio E10 have enought power for any headphone?
Yes, any headphone in the whole world!!!!
Wait, Kiteki, you've auditioned it?
What the output impedance?
Wait, Kiteki, you've auditioned it?
Originally Posted by JoetheArachnid /img/forum/go_quote.gif
I think that was sarcasm[...]
I think that was sarcasm based on the fact that 'will this be able to drive any headphone' is a pretty broad statement since there are always oddities like orthos, K-1000s and electrostats to confuse things.
EDIT: Also James, which distributors are likely to have this first? If it's going to be PJBOX again (for the UK at least) I'll have to keep an eye on their site.
Stay updated on FiiO at their sponsor profile on Head-Fi.
|