StevieDvd
Headphoneus Supremus
- Joined
- Jun 14, 2004
- Posts
- 1,742
- Likes
- 89
I've knocked up a new amp based on the gmoy I bought from Pinkfloyd and just needed to add the in/out connections and power/led etc and of course case it.
I'm using rca connectors in and a 1/4" jack and wondered whether I need to add a dummy load on the jack. I've not seen anyone adding these to basic cmoys in the past but then they are usually 1/8" jacks.
So is it necessary to put dummy load resistors on (and what value should I use)?
As soon as I've tidied it up a bit I'll post a few piccies just so my diy makes everyone else's look that much better
Thanks
Steve
I'm using rca connectors in and a 1/4" jack and wondered whether I need to add a dummy load on the jack. I've not seen anyone adding these to basic cmoys in the past but then they are usually 1/8" jacks.
So is it necessary to put dummy load resistors on (and what value should I use)?
As soon as I've tidied it up a bit I'll post a few piccies just so my diy makes everyone else's look that much better
Thanks
Steve