[medon]

BTW, is the new sound signature applied only to PCM input, or both PCM and DSD?

 

[medon]

can it be done in mac ?

according to the instructions: Yes.
I made an old Windows 10 notebook do the job, though.

 

[mat.1]

Can i get back to original firmware for Terminator 2 ?
after the update the sound skip all the time when using I2s and clock out .

 

[joseG86]

Can i get back to original firmware for Terminator 2 ?
after the update the sound skip all the time when using I2s and clock out .

Check in the webpage where you downloaded the new firmware from and look for more than 1 firmware, maybe 1.0 or something like that

This is what we got for the Pontus

 

[mat.1]

Check in the webpage where you downloaded the new firmware from and look for more than 1 firmware, maybe 1.0 or something like that

This is what we got for the Pontus

Thx

 

[DrCal]

Can i get back to original firmware for Terminator 2 ?
after the update the sound skip all the time when using I2s and clock out .

Did you configure I2S after update? Update resets I2S pin configuration

 

[reydelanada]

Hi,

Today I upgraded my Terminator + to latest firmware using an M2 macbook air. No problems at all. Smooth upgrade. Configured clock and i2s after to match again my Gaia DDC.

I spent like 2 hours of critical listening to well known tracks and I liked the change. Looks like it gained even more detail and "life". Hard to tell without an A/B test but quite happy.

 

[mat.1]

Did you configure I2S after update? Update resets I2S pin configuration

Yes , i configure the I2S .
after the update left and right was reverse, so i have to configure the I2S.

 

[Gary88]

Yes , i configure the I2S .
after the update left and right was reverse, so i have to configure the I2S.

I have the same experience left & right dsd channel swap. After run thru 000 to 111, seem like dac 111 setting is correct but need swap dsd channel. DDC remain 000.

 

[mat.1]

Alvin, Please Help.
Already back to firmware 1.0 , still have the skips .

 

[CAJames]

Alvin, Please Help.
Already back to firmware 1.0 , still have the skips .

And you’ve tried all the different I2S pinouts?

 

[mat.1]

And you’ve tried all the different I2S pinouts?

Yes

 

[mat.1]

Now I brick the terminator 2

 

[DrCal]

Have a problem with T+. Only USB input works now, I2S is dead. Tried various configurations and no luck

 

[DrCal]

Now going back to 1.0 hope it restores I2S ….