RisingTide
New Head-Fier
- Joined
- Nov 9, 2010
- Posts
- 14
- Likes
- 0
I've just bought parts and assembled them for my diy Cmoy Amp.
My cmoy schematics is based on this website http://williamneo.blogspot.com/2008/01/diy-cmoy-headphone-amplifier-for.html
And i'm stuck on Step 16
the part which im suppose to connect the volume control, 3.5mm input and output, im not sure which wire was suppose to be soldered to which part of the vol control and imput/output jack as it wasn't stated in the pic.
These are the parts i've bought.
The 10K Volume Control
3.5mm Input & Output Jack (front & back) Side (plugged in) Back (plugged in)
which of the 4 holes (North, South, East, West) on the jack was suppose to be the GND, *R* In, *R* Out, *L* In and *L* Out?
same goes for the volume control?
-Sincerely RisingTide
My cmoy schematics is based on this website http://williamneo.blogspot.com/2008/01/diy-cmoy-headphone-amplifier-for.html
And i'm stuck on Step 16
the part which im suppose to connect the volume control, 3.5mm input and output, im not sure which wire was suppose to be soldered to which part of the vol control and imput/output jack as it wasn't stated in the pic.
These are the parts i've bought.
The 10K Volume Control
3.5mm Input & Output Jack (front & back) Side (plugged in) Back (plugged in)
which of the 4 holes (North, South, East, West) on the jack was suppose to be the GND, *R* In, *R* Out, *L* In and *L* Out?
same goes for the volume control?
-Sincerely RisingTide