[Existence_Inc]

Is there a noticeable Amiron sound quality difference between M11 via Aptx-hd and M11 wired ?

With the sound profile set up through the app, I thought it sounded different than wired. Not sure if it sounded "better," just different. I wasn't really taken with it wired or wireless, so I ended up returning them.

~Ex

 

[kelly200269]

Is somewhere FR chart of Amiron wireless? Thx.

 

[migo]

Thank you! Not the nicest one. According to this FR it should be bass heavy, but to my ears is it opposite. What is source of this FR?

 

[migo]

Here is a picture of my Amiron Wireless Copper

Have you photo of opposite (inner) side of this EDT770 earpads by any chance? Thank you!

 

[kelly200269]

Thank you! Not the nicest one. According to this FR it should be bass heavy, but to my ears is it opposite. What is source of this FR?

You’re not reading the frequency response curves correctly.
What the Amiron Wireless FR curve shows is a ‘neutral’ sound signature, with relatively little bass enhancement.
Compare this to the FR curve for the Sony MDR-1000X above, and there is a major contrast. If you look at the ‘dip’ approaching 1K from the lower frequencies, this is what gives the Sony’s their relative ‘bass boost’. In comparison, the Amirons are relatively flat in this area.

 

[migo]

In the beginning they are hard yes but after using them for a while, they'll get soft but of course, it depends on people their head shapes. I like the stock ones because of the same colors and shades. But I wish I could use 770V pads but too scared to destroy it.

Here are two shots of pulling down earpads (MMX300) from my Amirons, maybe it will help you.

 

[migo]

You’re not reading the frequency response curves correctly.
What the Amiron Wireless FR curve shows is a ‘neutral’ sound signature, with relatively little bass enhancement.
Compare this to the FR curve for the Sony MDR-1000X above, and there is a major contrast. If you look at the ‘dip’ approaching 1K from the lower frequencies, this is what gives the Sony’s their relative ‘bass boost’. In comparison, the Amirons are relatively flat in this area.

Thank you, yes it depend of measurement environment and gear used, you need all measurements you want to compare done in this ONE representative conditions. I'm familiar with arta, I'm loudspeaker DIYer. I've compared your FR with FR on rtings.com site and they are not comparable. BTW, I've voted for Amirons to get tested by them: https://www.rtings.com/headphones/suggestions I've asked my friends to vote too. Maybe folks here can give some votes to Amiron too if they haven't own preference off-course.

 

[migo]

Here are shots of original Amiron earpads and BD MMX300 velour earpads that I've fitted now.

 

[CTR640]

Here are two shots of pulling down earpads (MMX300) from my Amirons, maybe it will help you.

To apply the pads successfully I have to use that small space there to insert it?

 

[migo]

To apply the pads successfully I have to use that small space there to insert it?

Yes, but you can use the trick with triangular cutout and circular move described in dekoni video, it is super easy. Or you can pull the plastic snap ring form HP with, I used my thumb finger nail and attach earpads on that ring and push that ring with attached earpads back to the HP.

 

[CTR640]

Yes, but you can use the trick with triangular cutout and circular move described in dekoni video, it is super easy. Or you can pull the plastic snap ring form HP with, I used my thumb finger nail and attach earpads on that ring and push that ring with attached earpads back to the HP.

With the thumb finger nail it's easier that way? Pulling is while the stock pad is still on the hp?

And yes, that's what I meant: the triangular cutout.

I have this too to open up devices for example:
https://image.dhgate.com/0x0s/f2-al...1-cep-telefonu-tamir-ara-lar-kiti-spudger.jpg

 

[migo]

With the thumb finger nail it's easier that way? Pulling is while the stock pad is still on the hp?

And yes, that's what I meant: the triangular cutout.

I have this too to open up devices for example:
https://image.dhgate.com/0x0s/f2-al...1-cep-telefonu-tamir-ara-lar-kiti-spudger.jpg

I haven't tried that way with earpads atached, simple always pulled earpads away. I pulled that snap ring away only to attach brainwawz earpads bcause they have soft borders on inner "lip" and can't be easily attached. I need to cut them with scisors too bcause they are long and can't by fitted under that ring.

 

[migo]

Ordered EDT770V earpads, will see how it performs...

 

[hifi80sman]

Anyone have any feedback on the call quality? What about sidetone (I prefer this when on calls so I don't yell). Looking for something to compliment my office.

 

[migo]

Anyone have any feedback on the call quality? What about sidetone (I prefer this when on calls so I don't yell). Looking for something to compliment my office.

Hi, for me was call/microphone quality OK, much better than ATH-DSR9BT = unusable for calls. But I've tested it only to check if it works.