funkthumb
New Head-Fier
- Joined
- Jan 24, 2013
- Posts
- 48
- Likes
- 10
I am glad to hear any and all opinions. Unfortunately I was blessed wit an AT yellow. Any suggestions as to what I should be using?
Likely used contact cement initially so SG may not be best depending on what's under the corner. It also looks bent/stressed. I'd clean off as much old glue as possible and than use some epoxy with a clamp from front to back. More contact cement probably won't due because of the tension.
I am glad to hear any and all opinions. Unfortunately I was blessed wit an AT yellow. Any suggestions as to what I should be using?
I was hoping to keep the price down as much as possible. I don't want the cheapest but I can't afford thousands so somewhere in the lower middle would be good, say 100 - 500$.
I still have to buy a brush, cleaner, new belt etc.
I am still new to this so I will take any and all suggestions into consideration. I do like to research things.
Thank you analogsurviver for all the help. I'm now starting to realize just what I've gotten myself into!! A 50$ test record, a 2-300$ cartridge, protractors, brushes, solutions, etc., etc., etc. !!!!! Holy cow it's a good thing that I got the table for relatively little money! I don't mind the expense but it's all going to be hard to sneak past my wife!
Another little thing that I've noticed is that I don't have room to put the table anywhere. So now I have to rearrange and buy new furniture for my components!!
I don't think I thought this through very well!