StanRex
100+ Head-Fier
- Joined
- May 20, 2007
- Posts
- 126
- Likes
- 0
Hey guys,
I ve got 2 little questions regarding casework.
First : the one that boggles me more
I have an rk27 and this volume knob : 45KN031
I ve tried attaching the knob to the pot using the small screw that is inside the knob, but the result doesnt feel too good. The knob simply tends to slide on the shaft of the pot.
My question was : should I drill a hole in the shaft of the pot and line it with the screw inside the knob? or is there another trick?
And my last questions , regarding safety this time : I ve cut a few round holes in an aluminum case using a dremel with a cutoff wheel, and found it created quite a bit of dust.
Would you suggest buying protection glasses/mask or are those only useful for pro and not hobbyist who aren't exposed as often?
thanks in advance for your answers
I ve got 2 little questions regarding casework.
First : the one that boggles me more
I have an rk27 and this volume knob : 45KN031
I ve tried attaching the knob to the pot using the small screw that is inside the knob, but the result doesnt feel too good. The knob simply tends to slide on the shaft of the pot.
My question was : should I drill a hole in the shaft of the pot and line it with the screw inside the knob? or is there another trick?
And my last questions , regarding safety this time : I ve cut a few round holes in an aluminum case using a dremel with a cutoff wheel, and found it created quite a bit of dust.
Would you suggest buying protection glasses/mask or are those only useful for pro and not hobbyist who aren't exposed as often?
thanks in advance for your answers