Hi everyone, I am trying to fix my SONY MDR-1R. The left side is working but the right side is not. The problem is that for the left side I am not sure about the place where to solder the wires connected to the right side (yellow and red wires). If someone has an idea where the wires must go I...

Dear Head-Fi community, My beloved IE80s have ripped, its been over 4 years since I owned them. I have a picture below of what it looks like. Sound doesn't come out of the earphone anymore... Any advice/ideas what I should do? Another image below https://i.imgur.com/9cGYFHe.jpg If...

my first question is 1) where can i find 1mm 2 core wire to use in the internal headband of the headphones? I was able to find some on ebay that were meant for beats solo but that runs for $6-$8 for about 2 feet of wire which i think is a bit over priced. So I was hoping to find a cheaper...

I can't use regular stranded wire. The way the wire travels through the headphones and is constructed requires wire that is smaller than 1.5mm outer diameter (26 AWG). The original wire I believe is 30 AWG however i can use 28 AWG since it'd fit. 26 awg is too thick. Its gotta be a single...

The wire is still connected to the inside components of the ear cup so I don't have to take that apart to solder them and the other end of the wire is still in the headband but i was able to get some slack of it. How can I lengthen them? Is there a way to buy copper wire that fits and I can...