Fantastic head-fier ! That sums all.

That is a shame. That wasn't my preferred filters in the 004... Thanks

Hi Lennym Which filters are available for PCM in the 005? Thanks

b0bb Did you find ainy significant improvements when switching to the Belleson regulator?

Bobb Why he would do that? Why would he have the work to do a picture with certain resistor values, if it wasn't safe and he know it is ok? After all, we all enjoying his creation. They made some bad choices in the layout but they also made very good ones. If it weren't from lks we aren't here...

Hi What I can say is that the modification in the resistors was given to me by Jinbo, the creator of our dacs, when I asked him if I can use the 0.1 uf of the 005. He said yes but I have to change the resistors in the picture he sent me and that you posted here. Best

I have been using the Sitime 5357 for a long time now. It is my favourite with the DAC. Never looked back. Great definition in all the aspects of the music. It may not have the low phase of the crystek and the accusilicon but I didn't miss it one bit. It, however, has great frequency stability...

Hi Thanks for the answer and the help The thing is to know what fixed voltage sparkos i have to order, i have to check after the lm317 adjuster voltage resistor and you have to follow all the pcb tracing to the next pad and then check the voltage which can be hard to figure and takes some time...

Hi guys I am thinking of replacing all the LM317 regulators for a better ones. Is the regulated voltage for all 3 LM317 5v or there is any that supply 3.3v? Thanks for the help

Nice Job! Unfortunatelly, i don´t have the technical skils to help with your question. A question myself : At which temperature did you use heat gun to solder the sitime?

Hi I didn´t read the spec sheet at detail, so i didn´t know about the diodes, so i didn´t installed it. Anyway, i didn´t connect the NC pins to ground (Only one is connected but is more to secure the tcxo with four legs, one leg in which corner/pad). I don´t have here with me any picture but...

Personally, i soldered some small pure silver wires to the TCXO pads and then soldered them to a RHEA board, which is made by twisted pear . I already had placed a modified 14dip in that pads available for that in the dac board to allow easy switching of the Dac clock.

Yes,that is the one . I bought at arrow.com, which at the time, was cheaper.

I am using one sitime 5157 0.5ppm . In my opinion is great. I tried 950x.575x and one or other and i keep going back to this. In my opinion the best quality of it is that is very neutral to the source.

Hi Guys A little help if someone know the answer. Anyone knows what are the value of the blue capacitors in the image? 0.1 uf ? ( 0.1 uf is just for example so you can know which value i am talking about)