-
-
Which you can probably throw out now, because neodymium magnet will damage the internal (permanent) magnet of the BA. Speaking from... -
So I have all the parts and pieces to build the piotrus-g scary crossover build. I'm going to use size 1206 SMDs. I found some thin pcb...
-
slakoth453 replied to the thread Home-Made IEMs.Just use some glue, the uv resin works well but you need to be careful with vented drivers. In this case I felt like the tubes were...
-
slakoth453 replied to the thread Home-Made IEMs.Thanks! Yep, these are 3d printed.
-
Time to raid your home and steal those iems
-
slakoth453 replied to the thread Home-Made IEMs.I haven't actually worked with an SWFK, only an e-audio clone. I posted about that set a while back (page 967) but can't really say if...
-
slakoth453 replied to the thread Home-Made IEMs.Thanks! Do you mean the lacquer on the faceplate? It's not perfect, the camera makes it look better than it is. RAU sounds nice but the...
-
slakoth453 replied to the thread Home-Made IEMs.Finally had time to finish another set. 2x huayunxin CN10, 2389D and RAU.
-
-
As a rule of thumb I always solder the wires to the female jack with the cable plugged. It helps dissipate the heat and reduce the...
-
My newest build of my hybrid IEM. It consists of 10mm DDx1 / 37ap015x1 / E50DTx2 / 31736x1 Total 1DD with 8 BAs driver. 4 tubes with 4...
-
Extension-wise it is the very best driver I've seen, nothing comes close to it, not RAU, not any of the ESTs or any other planars I've...
-
slakoth453 replied to the thread Home-Made IEMs.Rinko even has double sided magnets and from the pictures it doesn't look like it has a surround. I admit that I did think it looked...
-
But the coil is flat on the diaphragm, the only difference is that the coil is not printed on the diaphragm, which I assume is that you...
-
slakoth453 replied to the thread Home-Made IEMs.Are you referring to the SPD or seeaudio rinko? The rinko is basically a planar but not a very good one.
-
slakoth453 replied to the thread Home-Made IEMs.Yeah the hs14pd the one I was talking about. The other is a dd.
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…
